Installation Instructions
CE-606
The CE-606 regulator is designed for use on 2006-2008 FLH-FLT.
Remove Old Regulator
1) Remove the two-¼ 20 nuts
that hold the regulator on.
2) Remove the wire clamps and
save for reassembly.
3) Lift the regulator off the
mounting studs and tilt it forward to access the wire connections.
3) Remove the locking clips
and disconnect the stator and battery plugs.
Install New Regulator
Note: The stator and battery
plugs can be connected before or after the regulator is mounted on the bike. If
you do not have a lift it may be easier to connect the wires before mounting
the regulator.
1) Remove the retaining clips
from the stator and battery connectors on the new regulator. Save them for
reassembly.
2) Place the regulator on the mounting studs. The regulator should sit
directly on the frame. Reuse the old wire clamps. Install them on top of
the regulator mounting foot. Reuse the stock ¼’ nuts to fasten the
regulator to the frame.
3) Connect the stator and
battery plugs.
4) Install one plug-retaining
clip on each plug.
5) Check the routing of all
wires to be sure they are not in a vulnerable position. Keep wires away from
exhaust pipes and moving parts. Be sure wires are not in the very bottom of
lower frame or they will get pinched if you bottom out.
6) Start the motor and check
battery voltage. Battery voltage should run 14.4 to 14.6 volts.
Have A Good Ride!!
For complete product listing
and technical information see our web site.
REV. 3-10